Burkert Type KK02 5M Cable with Sub-D socket, 25 pin

Burkert Type SET3 - Wearing part set

Seametrics has released a new connector for the internal data logger option on iMAG 4700, AG3000, AG90 and EX90 products. This new 5-pin connector does require a new download cable for data transfer.

The RSP5 solar panel makes it possible to use Seametrics flowmeters in remote applications where a reliable source of electricity is not available or practical. The RSP5 is intended for use with a standard 12V, 22-33 Amp-hour Sealed Lead Acid battery (not included). It comes standard with a charge controller and corrosion resistant mounting hardware. The RSP5 can also be used to provide up to a 40-day back-up power supply for periods of darkness.

The Sensorex SDA differential sensor salt bridge replacements extend the lifetime for SD7000 differential pH and ORP (REDOX) sensors. Also compatible with other brands, including Hach* and Water Analytics.* Available in single unit or pack of three (3) units. 

Walchem 3/4" In-Line Mounting Tee

Walchem Orifice Union, 3⁄4", with 4 Orifice plates, 0-1000 psi.  Orifice Unions offer back pressure and flow control, limited by the available orifice sizes. Each union is supplied with four plates.

Walchem Electrode for WCT/WDT400 

Walchem Flow Switch Manifold switch assembly

Walchem in-line mounting nut for low pressure sensor mounting or WEL electrode mounting

Walchem Membrane Cap, 20 ppm Free Chlorine/Bromine (Extended pH range) and 20 ppm Total Chlorine

Walchem Membrane Cap, 20 ppm Free Chlorine/Bromine (Extended pH range) and 20 ppm Total Chlorine

Walchem Membrane Cap, 20 ppm Free Chlorine/Bromine (Extended pH range) and 20 ppm Total Chlorine

Walchem O-ring, FKM, for low pressure sensor mounting