Truflo - Pulsepro Pulsation Dampener Series
Prevent siphoning and stabilize dosage rates with SENTINEL Diaphragm Back Pressure Valves.
Blacoh’s Sentinel 316 Stainless Steel Check Valves ensure chemical flow only goes in one direction, with quality-machined construction for reliability and maximum performance.
Protect pumping systems from pressure damage with SENTINEL Diaphragm Pressure Relief Valves.
Blue-White Industries S6A Chemical Feed Flowmeter:
Burkert 2000 Angle-Seat valve is operated with a single or double-acting position actuator.
Burkert 2031 NPT Stainless Steel diaphragm valve is an alternative to ball valves for polluted, dirty, abrasive or high viscosity fluids.
Burkert 2702 control valve consists of an 316L angle seat body with a rugged pneumatic piston actuator.
Burkert 6012 is a 3/2-way miniature solenoid valve.
The Burkert 6013 is a 2/2-way miniature solenoid valve.
The Burkert 6014 P is a 3/2-way direct mounting pilot valve and is designed for quick mounting onto pneumatic actuators e.g. process valves.
The Burkert 6128 is a 2/2 or 3/2-way rocker solenoid valve. It combines all state of the art features in a compact design.
The Burkert 6213 is a 2/2-way solenoid valve for fluids.
The Burkert 6511 are high switch reliability diaphragm valves in 3/2 and 5/2 way versions.
The 8025 by Burkert is a digital flow transmitter for continuous flow measurement.
The 8035 by Burkert is an INLINE flow transmitter/batching unit.
The 8055 by Burkert is a full bore mag flow meter for continuous or batch control.
The 8110 by Burkert is a vibrating level switch for liquids using a tuning fork for level detection.
The Burkert 8136 is an OEM radar transmitter, for aggressive media level measurement.
The Burkert 8137 is a general-purpose high-pressure radar level transmitter.
The Burkert 8175 is an ultrasonic non-contact level transmitter.
The Burkert 8323 pressure transmitter is designed to cover the majority of industrial applications in the field of industrial pressure measurement technology.
The Burkert 8327 intrinsically safe pressure transmitter is designed to cover the majority of industrial applications in the field of industrial pressure measurement technology.
The Burkert 8400 is an intelligent sensor/switch with an extra- large display is specifically designed to switch a valve and to establish a monitoring system or an ON/OFF control loop.
The Burkert S020 is an insertion fitting for flow measurements or analysis.
The Burkert S030 is an INLINE fitting with paddlewheel for flow measurement.
The Burkert TST001 is a temperature thermometer with 1xPt100-temperature probe integrated in stainless steel tube.
Burkert Type 0281 2-way solenoid valve, internally piloted, normally closed (circuit function A) or normally open (circuit function B)
The Burkert 0290 valve is a servo-assisted solenoid valve of the S.EV series. The valve opens without differential pressure. The opening process is supported by the fixed coupling of the diaphragm to the plunger.
This Burkert valve is highly reliable alternative to a ball valve. The plug has a linear travel, so it does not cut across the seats as in a typical ball valve. Operational life typically exceeds 5 million cycles in water service. The soft seal on the valve plug lifts safely off the seat and out of the flow system, allowing fora long life.
The cable plug Type 2509 is used to connect devices and components, especially solenoid valves with plugpin assignment A according to ISO 4400.
Burkert Type KK02 5M Cable with Sub-D socket, 25 pin
The Burkert fitting can be used to connect any Insertion device for a measurement in the pipe. e. g. for flow, pH, oxidation reduction potential (O.R.P) and conductivity measurement.
The Burkert sensor-fitting S030 has a built-in paddle wheel to measure the flow rate. When liquid flows through the pipe, the paddle wheel is set in rotation producing pulses whose frequency is proportional to the flow rate.
Burkert Type SET3 - Wearing part set
Type SET6 - Valve & plug sets
CSA approved intrinsically safe for use in general purpose or hazardous applications, the two-wire ultrasonic transmitter provides non-contact level measurement up to 18' or 5.4m, and is ideally suited for challenging corrosive, slurry or waste liquids.
Offered in both vertical and horizontal float configurations, the general purpose high-temp float level switches are an ideal choice for relatively clean water, diluted chemical or petroleum based liquids with non-coating and/or scaling characteristics.
The general purpose controller has a graphic display with four 4-20 mA transmitter input channels and 6 programmable relays.
The Flowline SwitchPoint compact junction box is offered in small and large sizes.
The general purpose meter displays engineering units with one 4-20 mA or 0-10 VDC transmitter input channel and is offered in three configurations with optional 2 or 4 relays, 4 or 8 set points and an isolated 4-20 mA repeater.
The Flowline DataLoop II safe loop powered meter is intrinsically safe and has general-purpose configurations.
The general purpose two-wire pressure transmitter is offered in two termination packages and provides contact level measurement up to 69' or 21.1m of water column.
The general purpose two-wire pressure transmitter is offered in two configurations for different liquid types and provides contact level measurement up to 46' or 14m of water column.
The Flowline EchoPod® controller is a general purpose, ultrasonic sensor that provides non-contact level detection up to 98.4" (2.5m).
Forgot your password?
Thank you for contacting us!
Your message has been sent and someone will be contacting you shortly.
In the meantime, if you have any questions please feel free to call us at 800.370.0439.
The Maltz Sales Team